The 2-Minute Rule for mechanical mod



During the inventory form, the schematic claims the facility valves need to see about 350V to the EL84’s, which is by now really superior as far as latest creation valves go. Just after fitting from the choke, This could go greater, to probably 370V which is de facto beginning to push the boundaries.

The material of the human body and the standard of its threads can have an impact on voltage loss. Vapers concerned with performance try to look for mech mods that use very conductive metals and have exact threads.

Hence concludes the mods that I have currently accomplished on my Vox AC15CC. There are plenty of a lot more mods which could perhaps be carried out and I'll keep on to update this article as I conduct them.

Thanks for stopping by and submitting a remark. I believe the only mods remaining, to fully iron out the weak spots for AC15, is to change many of the coupling caps to Sozo’s, and to replace the output transformer having a Mercury Magnetics.

The next is a pretty large improve – you should use warning – I replaced all the next factors (note: your solder expertise will likely be tested carrying out this, so don’t go into this unprepared)

Protections: over puffing protection/small voltage alert/atomizer brief-circuit security/charging defense

It's possible try out some JJ EL-eighty four’s and find out if that helps help your very low conclude. JJ’s are encouraged being an enhancement in excess of the inventory valves the amp comes along with.

Seems gorgeous and well set collectively. A really nice pcb And that i need to say I had been pleasantly stunned.

what you need to do when putting in the 250k Pot, would be to wire among the list of pads to Leg three and another pad to the wiper (middle leg) of the pot. The opposite leg might be still left untouched. They are the pads from R23.

This is amazingly straightforward, easy to complete and properly truly worth the hassle of Mastering to get it done your self. Knowing how to alter your valves will save you dollars, in place of being forced to get it to an amp tech (Until not surprisingly, you suspect something else is Incorrect like on Facebook with the amp).

You will need to remove the rooster head knobs from your pots, and then eliminate the minor nuts that secure the pots to your chassis.

I've several Allen Bradley 220k carbon composite 0.25w resistors here which have been left over from Yet another project so would I be capable to use these 0.25w resistors for this V1 mod or do I really have to stick with a 1w resistor.

A good idea is to suit a toggle swap, allowing for you to swap conveniently between both of those settings, much like the AC30CC.

How really hard wouldn't it be to replace the input jack with one particular of better high-quality and dispose of the pcb board jack altogether? Say, exchange it using a Switchcraft jack.

Leave a Reply

Your email address will not be published. Required fields are marked *